Table of Contents
Advertisement
Install Software on the NI Smart Camera
Acquire an Image with Vision Builder AI
© National Instruments Corporation
2.
If you want to prevent other users from configuring the device, select
Enable Password and click Set Password to set up password
protection.
3.
Click Next.
Complete the following steps to install software from the development
computer to the NI 177x Smart Camera.
1.
In the Remote Target Configuration Wizard, enable the Update
Target Software checkbox.
2.
Click the Browse button next to the Software Image to Install on the
Target control.
3.
Navigate to the Vision Builder AI software image you want to use, and
click OK. Software images provided by National Instruments are
installed to the
<Vision Builder AI>\RT Images
<Vision Builder AI>
installed.
4.
Click OK to apply the IP configuration settings and download
software to the device.
5.
Click OK to close the Remote Target Configuration Successful dialog
box.
Complete the following steps to acquire an image using Vision Builder AI.
1.
On the Vision Builder AI welcome screen, select the NI 177x Smart
Camera in the list of targets.
2.
Click Acquire Image (Smart Camera) Example. The image
acquisition example opens in the Vision Builder AI Configuration
Interface.
3.
Click the Run Inspection Once button to acquire a single image.
4.
In the State Configuration Window, select the Acquire Image (Smart
Camera) step.
5.
Click the Edit Step button. The property page for the step opens.
6.
Use the controls on the Main, Color, Trigger, Lighting, or Advanced
tabs to configure additional settings for your application.
7.
Click OK to save the step configuration.
is the location where Vision Builder AI is
2-3
Chapter 2
Software Overview
directory, where
NI 177x Smart Camera User Manual
Advertisement
Table of Contents
