Table of Contents
Advertisement
Install Software on the NI Smart Camera
Complete the following steps to install software from the development computer to the NI 17xx
Smart Camera.
1.
In the Remote Target Configuration Wizard, enable the Update Target Software
checkbox.
2.
Click the Browse button next to the Software Image to Install on the Target control.
3.
Navigate to the Vision Builder AI software image you want to use, and click OK. Software
images provided by National Instruments are installed to the
directory, where
RT Images
Builder AI is installed.
4.
Click OK to apply the IP configuration settings and download software to the device.
5.
Click OK to close the Remote Target Configuration Successful dialog box.
Acquire an Image with Vision Builder AI
Complete the following steps to acquire an image using Vision Builder AI.
1.
On the Vision Builder AI welcome screen, select the NI 17xx Smart Camera in the list of
targets.
2.
Click Acquire Image (Smart Camera) Example. The image acquisition example opens
in the Vision Builder AI Configuration Interface.
3.
Click the Run Inspection Once button to acquire a single image.
4.
In the State Configuration Window, select the Acquire Image (Smart Camera) step.
5.
Click the Edit Step button. The property page for the step opens.
6.
Use the controls on the Main, Trigger, Lighting, Calibration or Advanced tabs to
configure additional settings for your application.
7.
Click OK to save the step configuration.
The NI 17xx Smart Camera is now configured and acquiring images. Use Vision Builder AI to
add and configure additional inspection steps to create your application. Refer to the
Documentation
section in the introduction to this manual for a list of documentation and other
resources to help you set up and use the NI 17xx Smart Camera in an application.
<Vision Builder AI>
NI 17xx User Manual
<Vision Builder AI>\
is the location where Vision
© National Instruments | 2-3
Related
Advertisement
Table of Contents
