Device Installation; Installation Steps - Dahua DH-IPC-HDBW4421EP-0280B Quick Start Manual

Hd ir vandal proof network dome camera

Table of Contents

Dahua HD IR Vandal Proof Network Dome Camera Quick Start Guide

2 Device Installation

Important

Before the installation, please make sure the installation environments can at least support 3x

weight of the camera.

Please follow the steps listed below to install the device. Please refer to Figure 2-1 for reference.

Step 1

Use inner hex wrench in the accessories bag to open dome enclosure by unfastening three inner hex

screws on enclosure.

Step 2

Please take the installation position map in the accessories bag, and then paste it on the ceiling or the

wall according to your monitor area requirements.

Step 3

Find cross signs on the map, and dig three plastic expansion bolts holes in the installation surface and

then insert three expansion bolts in the holes. Secure these three bolts firmly.

Note:



If use pulls out cable from top of installation surface, you must dig a exit hole on installation

surface according to the installation position map.



If user pulls out cable from side of cable channel, it must go through the U-shape channel on

dome pedestal, and take out cable from the side exit hole on pedestal.

Step 4

Adjust the device installation pedestal to the proper position and then pull cable through the exit hole

on Installation surface. Make direction of TOP sign same as it on installation position map. Line up the

three screw holes in the device pedestal to the three plastic expansion bolt holes in the installation

position. Put the three self-tapping screws in the three plastic expansion bolts firmly. Fix dome body on

installation surface.

Step 5

Hold bottom of bracket with hand, horizontally rotate bracket, adjusting lens direction to designated

position. Loosen one M2 screw on LED decoration cover (loosen only, do not take it down), hold the

decoration cover with hand, making lens rotate vertically. Adjust vertical direction of lens to appropriate

angle, and fasten the M2 screw. Range of lens: vertical (0°～+65°), horizontal (0°～+355°). See

Figure 2-2.

Table of Contents