Base Mounting - Grizzly G4176 Owner's Manual

base Mounting

position the power feeder on the table top to
determine where to drill your base mounting
holes, so you can maximize power feeder swing
and adjustment options.
there are two mounting options available:
Through Bolt Mounting and Direct Mounting
(discussed on Page 15). Choose an option that
suits your requirements.
Shaper
Figure 8. typical power feed mounting on a shaper, jointer, and tablesaw.
-14-
Whichever way you mount your power feeder,
you must be able to use the handcranks and lock
levers to position the rubber wheels parallel with
the table surface and
of your workpiece.
also, you must be able to point the power feeder
slightly towards the machine fence (Figure 8). in
other words, the tracking of the power feeder must
be toed-in approximately 1° to 1.5° degrees toward
the machine fence so the rubber wheels slightly
push the workpiece against the fence during cut-
ting operations.
Jointer
⁄ " lower than the thickness
1
8
Tablesaw
Model g4176 ⁄ hp power Feeder
1
4