Base Mounting - Grizzly G4173 Owner's Manual

base Mounting

position the power feeder on the table top to
determine where to drill your base mounting
holes, so you can maximize power feeder swing
and adjustment options.
there are thee mounting options available:
Through Bolt Mounting, Direct Mounting, and
Quick Holder Kit Mounting (discussed on Page
17). Choose an option that suits your require-
ments.
Shaper
Figure 15. typical power feed mounting on a shaper, jointer, and tablesaw.
-16-
Whichever way you mount your power feeder,
you must be able to use the handwheels and lock
levers to position the rubber wheels parallel with
the table surface and
of your workpiece.
also, you must be able to point the power feeder
slightly towards the machine fence (Figure 15). in
other words, the tracking of the power feeder must
be toed-in approximately 1° to 1.5° degrees toward
the machine fence so the rubber wheels slightly
push the workpiece against the fence during cut-
ting operations.
Jointer
⁄ lower than the thickness
1
"
8
Tablesaw
Model g4173 ⁄ hp power Feeder
1
8