EIP CS90H Owner's Manual page 2

Designed for a wide range of applications, the CS90H dehumidifier is a
rugged, industrial unit which utilizes an energy-efficient compressor and a
compact portable design to provide easy efficient drying.
The CS90H has a number of special features:
•
Compact Size
•
High efficiency rotary compressor
•
Ebac's "Hot Gas" defrost system
•
Exterior epoxy powder-coated finish
•
Provision for permanent drainage
•
Extra long power cord
•
Integral condensate pump
•
Digital humidistat controller
The fan draws the moist air through the cold evaporator coil, which cools the
air below its dew point. Moisture forms on the evaporator coil and is collected
in the condensate tray, which is equipped with a permanent drain. The cooled
air then passes through the hot condenser coil where it is reheated using the
same energy removed during the cooling phase, plus the additional heat
generated by the compressor. The air is, therefore, discharged from the
dehumidifier at a slightly higher temperature with a lower absolute humidity
than that which entered.
dehumidifier gradually reduces the relative humidity within the area.
A digital Humidistat is included which allows for precise humidity control. A
programmable display lets you set a specific desired humidity level.
The CS90H dehumidifier is a rugged, reliable drying unit designed to operate
effectively over a broad range of temperature and humidity conditions. An
active hot gas defrost system, controlled by an electronic timer, guarantees
positive de-icing, thereby optimizing operation at low temperatures.
The unit incorporates a welded and galvanized steel chassis and is finished in
an epoxy coating for resilience to damage caused by rough handling.
Get In Touch
Call: 0845 6880112
Email: info@adremit.co.uk
INTRODUCTION
Continuous circulation of air through the
Page 2 of 12
Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH
Drawing : - TPC444
Issue : - 3
Date : - 24/11/16