Electrolux EKG911A3 User Manual page 23

13.1 What to do if...
Problem
There is no spark when
you try to activate the
spark generator.
There is no spark when
you try to activate the
spark generator.
There is no spark when
you try to activate the
spark generator.
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
The burners do not work.
The appliance makes
noises.
The flame colour is orange
or yellow.
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
The oven does not heat
up.
The turnspit does not ro‐
tate.
It takes too long to cook
the dishes or they cook too
quickly.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heat‐
ed up sufficiently.
Burner crown is blocked
with food residues.
There is no gas supply.
The lamp is defective.
You left the dish in the
oven for too long.
The necessary settings are
not set.
The turnspit is not correctly
installed into the turnspit
hole.
The temperature is too low
or too high.
ENGLISH
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the spark generator
activated for equal or less
than 10 seconds
Make sure that the injector
is not blocked and the
burner crown is clean.
Check the gas connection.
Some metal parts of the
appliance expand and con‐
tract when they heat up or
cool down. The noises are
normal.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Make sure that the settings
are correct.
Refer to "Using the turn‐
spit".
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
23