Specifications - Makita 2107FK Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Speed adjusting dial
3-1. Lamp switch
4-1. Tighten
4-2. Loosen
4-3. Protrusion
4-4. Lever
5-1. Blade
5-2. Bearing

SPECIFICATIONS

Max. cutting capacity
Blade size
Overall dimensions
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in wood, plastic and
ferrous materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Explanation of general view
5-3. Upper holder
5-4. Lower holder
6-1. Upper holder
6-2. Lower holder
6-3. Wheel
6-4. Press
7-1. Screw
7-2. Stopper plate
7-3. Blade
10-1. Cutting wax
Model
Round workpiece
Rectangular workpiece
Blade speed
Length
Width
Thickness
H x W x L
Net weight
Safety class
) : 86 dB (A)
pA
) : 98 dB (A)
WA
value (tri-axial vector
ENE009-1
Work mode : cuttig chipbord
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
sum) exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
11-1. Wheel
11-2. Tire
11-3. Lip
12-1. Fluorescent tube
12-2. lump box
12-3. Tapping screw
13-1. Limit mark
14-1. Screwdriver
14-2. Brush holder cap
2107F
120 mm dia.
120 mm x 120 mm
1.0 - 1.7 m/s
1,140 mm
13 mm
0.5 mm
496 mm x 184 mm x 249 mm
6.0 kg
/II
) : 2.5 m/s
h,CW
2
) : 2.5 m/s
h,CM
2
2
or less
2
or less
ENG901-1