Site Considerations; Stand - Grizzly G0532 Owner's Manual

Site Considerations

Floor Load
Refer to the Machine Data Sheet for the weight
and footprint specifications of your machine.
Some floors may require additional reinforcement
to support both the machine and operator.
Working Clearances
Consider existing and future needs, size of mate-
rial to be processed through each machine, and
space for auxiliary stands, work tables or other
machinery when establishing a location for your
new machine. Make a note of the exhaust fan
location. (See Safety on Page 8.) See Figure 3
for the minimum working clearances.
48"
3
. Minimum working clearances (top
Figure
view).
Unsupervised children and
visitors inside your shop
could cause serious per-
sonal injury to themselves.
Lock all entrances to the
shop when you are away and
DO NOT allow unsupervised
children or visitors in your
shop at any time!
G0532 2HP Dry Spray Booth
Components and Hardware Needed: Qty
Leg Support (Long) ........................................... 2
Leg Support (Short) ........................................... 2
Leg ................................................................... 4
Exhaust Fan ...................................................... 1
Hex Bolts
Flat Washers
Hex Nuts
Casters .............................................................. 4
Hex Bolts
Flat Washers
Hex Nuts
To install the support legs:
1.
2.
68"

Stand

⁄ "-16 x ⁄ " ................................. 32
3 3
8 4
⁄ " .............................................. 64
3
8
⁄ "-16 .............................................. 32
3
8
⁄ ⁄ "
"-18 x 3 ..................................... 16
5
4
16
" ............................................. 32
⁄
5
16
⁄ "-18 .............................................. 16
5
16
Carefully place the exhaust fan on its side on
the floor.
Place a leg over opposite corners of the
exhaust fan and fasten each leg with four
⁄ "-16 x ⁄ " hex bolts, eight flat washers and
3 3
8 4
four hex nuts as shown in Figure 4.
Note : Do not completely tighten the hard-
ware at this time.
Figure 4. Legs installed onto exhaust fan.
-13-