Table of Contents
Advertisement
4.2.3
WAN Setup
The WAN settings can be referred to as the Public setting. All IP information in the WAN
settings is public IP addresses which are accessible on the Internet. 11n Broadband Router
supports 4 interfaces and 4 access types to WAN. Select one of the WAN connection modes
required by your ISP in the following WAN Setup Configuration page, the WAN setup pages
will vary depending on what kind of WAN Type you select.
Choose your WAN Interface and Access WAN type as the above mentioned, and click Next,
its associated settings will show up.
4.2.3.1
WAN Interface– Ethernet Port
If you are using an Ethernet cable to connect the Internet, please select Ethernet port.
4.2.3.2
WAN Interface– Wireless
If you are connecting the internet via wireless, please select Wireless and its associated
settings will show up underneath at the same time.
You can see a list of available Wireless networks. Select you preferred one to connect and
the Encryption type form the drop-down list.
4.2.3.3
WAN Access Type – Static IP
Choose Static IP Address if all WAN IP information is provided to you by your ISP. You will
need to enter the IP address, IP netmask and IP gateway as provided. Each entered fields
must be in the appropriate IP form, which are four IP octets separated by a dot (x.x.x.x). The
Router will not accept the IP address if it is not in this format. Fill in the DNS information
provided by your ISP; otherwise, Domain Name can't be used.
Click on Next button to go on next setting page.
4.2.3.4
WAN Access Type – Dynamic IP
28
Advertisement
Table of Contents
