IKEA IMH172DS1 Installation Instructions Manual page 5

3. Remove 2 screws attaching blower motor to back
of microwave oven.
A
A. Screws (in recessed holes)
4. Lift blower motor out of microwave oven.
A. Blower motor
5. Rotate blower motor 180° so that exhaust ports face
the back of microwave oven, and lower blower motor
back into the microwave oven.
A. Exhaust port
6. Reattach blower motor to back of microwave oven
with 2 screws removed in step 3.
7. Reattach damper plate. Make sure damper plate tabs are
inserted into the slots in the top of the microwave oven.
A
D
A. Damper plate
B. Screws
C. Damper plate tabs
D. Slots
8. Secure damper plate with 2 screws removed in Step 1.
A
A
B
C
Roof Venting Installation Only
1. Repeat Step 1 from "Wall Venting Installation Only."
2. Repeat Step 2 from "Wall Venting Installation Only."
3. Repeat Step 3 from "Wall Venting Installation Only."
4. Repeat Step 4 from "Wall Venting Installation Only."
5. Rotate blower motor so that exhaust ports face the top
of microwave oven and flat sides of blower motor face
back of microwave oven. Lower blower motor back into
microwave oven.
A. Exhaust port
IMPORTANT: If blower motor is not positioned with flat sides
facing the back of the microwave oven (as shown), performance
will be poor.
6. Reattach blower motor to back of microwave oven with 2
screws removed in Step 3 of "Wall Venting Installation Only."
Securely tighten screws.
NOTE: If blower motor is not correctly oriented, the 2 screws
removed in Step 3 cannot be reattached to the microwave oven.
7. Reattach damper plate. Make sure damper plate tabs are
inserted into the slots in the top of the microwave oven.
A
D
A. Damper plate
B. Screws
C. Damper plate tabs
D. Slots
8. Secure damper plate with 2 screws removed in Step 1 of
"Wall Venting Installation Only."
A
B
C
5