Table of Contents
Advertisement
3.2 Use of Controls – Fig. 3.3(a) to (g)
Page 1
Frame 1
Frame 2
Frame 3
Return from
Frame 4
any frame
Fig. 3.3(a) Advancing to Next Page
Advance to
next Frame
Fig. 3.3(b) Moving Between Parameters
Parameter Value
Note. Continued pressure on the
causes the rate of change of the displayed value to
increase. To make small adjustments operate the keys
momentarily.
Fig. 3.3(c) Adjusting a Parameter Value
Parameter X
Note. Continued pressure on the
causes the rate of change of the displayed value to
increase. To make small adjustments operate the keys
momentarily
Fig. 3.3(d) Selecting a Parameter Choice
Page 2
Frame 1
Frame 2
Frame 3
Page X
Frame 1
Frame 2
Frame 3
Frame 4
Adjust
and
keys
Y
Select
Z
and
keys
3 DISPLAYS & CONTROLS
Lift/Lower pen on alternate operations
Note. If
is selected in the
'Auto Pen Drop'
Page, BASIC CONFIGURATION LEVEL
automatically to their operating positions after a five
minute delay.
Fig. 3.3(e) Lifting/Lowering the Pens
Information. The
key is programmed in the
Function Keys Page, ADVANCED CONFIGURATION
LEVEL.
Acknowledge any alarm
Auto-tune
Pen lift/lower
Profile ramp soak
Local /Remote
Return operator to top of
Op. Page
Page X
Parameter 1
Parameter 1
Parameter 2
Parameter 2
Note. The
key returns the instrument display to the
start of the operating page only when the display is at
the top of any page.
Fig. 3.3(f) Selecting Programmable Functions
Auto/Manual key – used for selecting Automatic or Manual
mode on alternate operations.
When manual mode is selected the displays revert
automatically to the process variable values and control
output or valve position (if position-proportioning or
boundless motorized valve control is selected at
in the
Type
Set Up Control Page
Fig. 3.3(g) Auto/Manual Key Functions
Set Up Chart
, the pens return
Set Up
or
.
Operating Page
Page X
Parameter 1
Parameter 2
Control
).
7
Advertisement
Table of Contents
