Advertisement
If machine is a manual dispense, there are no portion control adjustments to be made. (Please refer to serial tag to
reference model number.
Setting Single Portion Control
Place a cup under the selected drink
1.
dispense nozzle.
Press and hold the dispense
2.
switch.
Dispense Switch
After a 10 second time delay, the machine is triggered into
3.
program mode and will begin dispensing.
Continue pressing the button until cup is approximately
4.
2/3 full, then release the switch to prevent overfill. The
elapsed portion dispense time is saved to memory and
will remain until the dispense switch is reprogrammed.
Check the portion size by placing an empty cup under the
5.
desired dispense nozzle, the press and release the
dispense switch. The machine will dispense the
preprogrammed portion size.
If the portion size is incorrect, repeat above steps until the
6.
desired portion size is achieved. Each dispense switch
needs to be set separately.
Drink Strength Adjustment (Refer to Figures A and B)
Tools Required: #2 Phillips Screwdriver
Warning: Risk of Electric Shock! Always turn off power to machine while servicing or making
internal adjustments to machine.
1.
Dispense a drink to determine if drink is
too strong or too weak.
2.
Turn off power to machine at power switch.
NOTE: Clockwise rotation will result in a stronger drink and counterclockwise will result in a weaker drink.
NOTE: Water flow rate is factory preset at approximately 0.80 ounces per second.
Crathco
®
Powdered Beverage Dispensers
Portion Adjustment
Setting Three Portion Sizes Per Head
Place a cup under the selected drink
1.
dispense nozzle.
Press and hold the size button
2.
on the touch pad that you wish to
program or set. (Hold button
throughout entire procedure).
Then press and release the
manual (top-off) button ( ) .
There will be a 10 second delay
before the machine dispenses.
Continue pressing the size button until cup is approxi-
3.
mately 2/3 full, then release the switch to prevent overfill.
The elapsed portion dispense time is saved to memory
and will remain until the dispense switch is reprogrammed.
Check the portion size by placing an empty cup under the
4.
desired dispense nozzle, then press and release the
dispense switch. The machine will dispense the
preprogrammed portion size.
If the portion size is incorrect, repeat above steps until the
5.
desired portion size is achieved. Each portion size for
each head needs to be set separately.
3.
Remove upper front splash cover
below dispense heads in front of
machine.
4.
Using a flat head screwdriver, adjust individual dispense
heads by rotating appropriate adjustment knob. (See
Figures A and B on page 7). Turn on power to machine and dis-
pense a drink to determine if drink strength is acceptable, turn
off power to machine and repeat adjustment steps until desired
drink strength is achieved.
(optional on PIC 2/3/4 only)
*
Page 5
Advertisement
