Advertisement
Prepare for Shipment
Important: Always completely empty water tank and POWDER HOPPERS prior to shipping unit. (See Draining the
Tank and Cleaning the Hoppers section).
NEVER SHIP UNIT WITH POWDER IN HOPPER OR WATER IN TANK – THIS WILL CAUSE
Draining the Tank
Always empty the tank before shipping.
WARNING: Draining of the tank should be performed by a qualified service technician. The tank
contains very hot water. May cause severe burns.
NOTE: PIC 1 contains 2 gallons of hot water.
PIC 2, PIC 3 & PIC 4 contain 3-1/2 gallons of hot water.
PIC 5 and PIC 6 contain 5-1/2 gallons of hot water.
Prepare a heat resistant
1.
container to drain the tank
water into.
Unplug the machine.
2.
Remove the drain tray and
3.
front access panel.
Locate the silicone drain hose on the left side wall. Put
4.
the end of the drain hose into
the container. Secure the end
of the drain hose (i.e. with tape)
into the container.
Page 8
IRREPARABLE DAMAGE.
Pinch hose with fingers and
5.
remove the hose clamp
and plug.
Allow the tank to drain
6.
completely.
NOTE: It may be necessary to pinch
the hose and stop the water before
container is full. Carefully re-install
plug, then empty container. Repeat
steps 4-6 to completely drain tank.
Once the tank is empty,
7.
securely replace the plug and
clamp on the end of the hose.
Reposition the drain hose inside
the hose clip.
Reassemble the front access
8.
panel and drain tray.
Crathco
®
Powdered Beverage Dispensers
Advertisement
