Table of Contents
Advertisement
Camera menu items
■
System screen
This is the menu in which the camera's output image settings
are configured.
## System ##
Genlock
Output
Others
Return
Genlock
This displays the Genlock screen on which to perform the
phase adjustments.
Output
This displays the Output screen on which to select the
camera's output image settings.
Others
This displays the Others screen on which to select the
settings for the installation status of the camera's pan-tilt
head unit and operating speed as well as the settings
relating to the other functions.
Return
Use this to return to the previous menu.
44
(continued)
■
Genlock screen
This unit supports BBS (Black Burst Sync) and tri-level
synchronization.
External synchronization (genlock) can be applied to achieve
phase alignment when multiple cameras are to be used or
when the unit is to be used in combination with other devices.
### Genlock ###
Horizontal Phase
Horizontal Phase Step
Return
Horizontal Phase [–206 to +49]
This is used to adjust the horizontal phase during genlock.
Horizontal Phase Step [1 to 10]
This is selected to set the amount by which the [Horizontal
Phase] setting is to be adjusted.
Return
Use this to return to the previous menu.
Notes
● When a cable is connected to the G/L IN connector
and a valid synchronization signal is received, the
following operations are temporarily halted.
• Recording to an SD card
• IP image transmission
• Output from the HDMI terminal and SDI OUT
connectors
• Lens control
● The video signal of the SDI output may be temporarily
distorted or may not be output in the following cases.
• When the input signal to the G/L IN connector is
disrupted or changed.
• When a cable is connected to the G/L IN connector
or disconnected.
0
1
Advertisement
Table of Contents
