E-Ion Operation - Panasonic CS-A18GKD Service Manual

e. Indicator
• When Patrol operation starts, Patrol Sensor indicator ON.
• When e-ion operation starts based on dirtiness level, e-ion indicator ON.
f. Remote Control Receiving Sound
Normal Operation
•
Patrol Mode
•
Patrol Mode
•
Stop
•
g. Timer Control
• When ON timer activates when unit stops, previous operation resumes without Patrol operation.
• When ON timer activates during any operation, no change and carry on current operation.
• When OFF timer activates during any operation, all operation stops.
h. Power failure
• During Patrol individual operation, if power failure occurs, after power resumes, Patrol individual operation resumes
immediately.
• During combination operation, if power failure occurs, after power resumes combination operation resume immediately.

12.16. e-ion Operation

A. Purpose
This operation provides clean air by producing negative ions to attract dust captured at the positively charged e-ion filters.
B. Control Condition
a. e-ion operation start condition
• During unit running at any operation mode, if "e-ion" button is pressed, combination operation (operation mode + e-ion
operation) starts.
• During unit is OFF, if "e-ion" button is pressed, e-ion individual operation starts.
b. e-ion operation stop condition
• When "OFF/ON" button is pressed to stop the operation.
• When "e-ion" button is pressed again.
• When "Patrol" button is pressed.
• When OFF Timer activates.
c. e-ion operation pause condition
• When indoor fan stop (during deice, odor cut control, thermostat off, etc.). e-ion operation resume after indoor fan restarts.
• When indoor intake temperature 40°C. e-ion operation resume after indoor intake temperature < 40°C continuously for 30
minutes.
→ Patrol Mode
→ Stop
→ Normal Operation
→ Patrol
: Beep
: Long Beep
: Beep
: Beep
46