MULTIQUIP G3200105 Operation And Parts Manual page 7

LIGHTING SYSTEM SAFETY
WARNING
 NEVER disconnect any emergency or safety devices.
These devices are intended for operator safety.
Disconnection of these devices can cause severe injury,
bodily harm or even death. Disconnection of any of
these devices will void all warranties.
CAUTION
 NEVER attempt service on a running machine.
NOTICE
 To prevent the lighting system from overturning, NEVER
use in winds that exceed 22 mph (10 m/s).
 The lighting system should only be used in temperatures
between 23° to 104°F (-5° to 40° C). Failure to comply
with these operating parameters could cause the lamp
to malfunction and shorten the ballast life.
 ALWAYS keep the lighting system in proper running
condition.
 Fix damage to lighting system and replace any broken
parts immediately.
 ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
LAMP SAFETY
WARNING
 NEVER attempt to replace lamp with the power on.
Always unplug the power cord from the generator or
power source when changing the lamp.
 ALWAYS allow a suffi cient amount of time for the lamp to
cool before changing. The possibility exists of severe burns.
CAUTION
 NEVER use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
PAGE 8 —GB3LED/B LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/09/15)
SAFETY INFORMATION
NOTICE
 NEVER leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
 ALWAYS make sure lamp surface is clean and dry.
 ALWAYS replace with MQ recommended type lamp. See
parts section of this manual.
 If applicable, ALWAYS make sure the lamp guard is
installed correctly. NEVER deform the lamp guard.
 NEVER unplug the lamp's AC power cable during
operation.
 ALWAYS have a trained technician to install and
remove lamp or replace any damaged fi xture wiring.
TRANSPORTING SAFETY
NOTICE
 When transporting the tripod lighting system, if
applicable, always place in stow position and place
tripod in its carrying case.
 ALWAYS remove balloon/lamp assembly from the mast
when transporting lighting system. This will prevent
damage to the bulb due to vibration.
 NEVER leave the balloon/lamp exposed during transport.
Exposure to excess wind or rain could damage the
balloon's nylon cover.
 ALWAYS place balloon inside its protective cover during
transport. Be sure the cover is secured tightly around the
balloon/lamp assembly.