MULTIQUIP G3200105 Operation And Parts Manual page 20

7. To retract tripod legs (Figure 20) and place in the
stow position, lift up on mast while pulling up on the
velcro strap. Continue pulling upward on the mast until
the tripod legs are fully retracted and are in the stow
position.
LATCH
UPPER
LOWER
Figure 20. Retracting Tripod Legs
8. Once tripod legs are in the stow position, place velcro
strap (Figure 21) around all three tripod legs. Secure
tripod legs by inserting the male and female connector
ends of the strap into each other.
VELCRO
STRAP
BUCKLE
Figure 21. Velcro Strap (Closed)
GB3LED/B LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/09/15) — PAGE 21
MAST
TRIPOD
LEGS
CLICK
9. Place tripod (Figure 22) inside protective carrying case.
PROTECTIVE
CARRYING
CASE
Figure 22. Carrying Case
OPERATION
TRIPOD