MULTIQUIP G3200105 Operation And Parts Manual page 16

BALLOON ASSEMBLY PLACEMENT
1. Place balloon assembly (Figure 8) onto mast and
tighten Upper T-handle.
Figure 8. Light Asembly Placement
2. Unsnap the three buttons on the bottom of the balloon.
Expose the balloon by pulling down on the velcro tab
and unzip the protective cover as shown in Figure 9.
Also remove the AC power cord at this time.
ZIPPER
Figure 9. Removing Balloon/AC Power Cord
GB3LED/B LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/09/15) — PAGE 17
PROTECTIVE
COVER
UPPER
T-HANDLE
MAST
LOWER
T-HANDLE
BUTTON
3. Next, fold the protective cover (Figure 10) into itself
and zip.
PROTECTIVE
COVER
Figure 10. Folding Protective Cover
4. Attach the S-type hook (Figure 11) on the AC power
cable onto the washer-eylet located on the bottom plate
of the light assembly.
S-TYPE
HOOK
Figure 11. Securing Power Cord
SETUP
ZIPPER
BOTTOM
PLATE
WASHER
EYELET