MULTIQUIP G3200105 Operation And Parts Manual page 19

STORAGE
1. Loosen the lower T-handle by turning handle
counterclockwise (Figure 16). Push down on mast
until mast is fully inserted into mast housing. Tighten
T-handle fully.
Figure 16. Lowering the Mast
2. Unhook the cable from the washer eyelet.
3. Unzip the zipper on the protective cover (Figure 20),
and pull down cover over balloon/lamp assembly.
ZIPPER
Figure 17. Unzipping the Protective Cover
PAGE 20 —GB3LED/B LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/09/15)
LOWER
T-HANDLE
PROTECTIVE
COVER
4. Unhook lamp AC power cable from washer eyelet
(Figure 11). Fully zip protective cover and fold velcro
tab in place (Figure 18).
VELCRO
TAB
Figure 18. Zipping the Protective Cover
5. Loosen upper T-handle by turning counterclockwise
and lift lamp assembly from mast.
6. Store lamp assembly enclosed with its protective
cover (Figure 19) in a safe location where it will not
be damaged.
PROTECTIVE
COVER
Figure 19. Storing Lamp Assembly
OPERATION
PROTECTIVE
COVER
AC-POWER
CABLE