Using Wireless Speakers; Enabling/Disabling The Network Standby Function - Yamaha YMS-4080 Owner's Manual

Using wireless speakers

The following devices can be used as surround speakers or a
subwoofer with this unit.
• Devices such as the MusicCast 20 that support the MusicCast
Surround function and serve as "Pairing Devices"
• A Yamaha network subwoofer such as the MusicCast SUB 100
Left surround
speaker
1
Use the MusicCast CONTROLLER app to register
the unit, and devices used as surround speakers
and network subwoofer with the same location.
Subwoofer
Right surround
speaker
45
2
Specify the devices and/or network subwoofer that
will serve as the unit's speakers.
Tap ~ (Settings) in the app's room selection screen,
select a room registered with the unit in "Room
Settings", and then specify the devices to be used as
the unit's speakers.
NOTE
▪ This function will be made available through a future firmware update. For details,
refer to the website for this product.
▪ Functions and installation may vary depending upon the devices that support the
MusicCast Surround function (Pairing Devices) used. For details, see
documentation supplied with the device and network subwoofer.
Enabling/disabling the network standby
function
Enabling the network standby function allows the unit to be turned
on or off using a mobile or Bluetooth device as follows.
This function is enabled by default.
• When the unit is turned off, it will turn on with the following
playback operations.
– Music files are played using the AirPlay function.
– Music files stored on a network attached storage (NAS) unit are
played
• The unit can also be turned on and off using the MusicCast
CONTROLLER app installed on your mobile device.
• When a Bluetooth device is connected to this unit while it is off,
this unit turns on and the input source switched to BLUETOOTH.
1
Turn off the unit.
En