Test Details - Greenlee NETcat NC-500 Instruction Manual

Test Details

Voltage Checks
This test checks for a voltage in excess of 5 VDC across each pair. If a voltage is
detected above the stated threshold, then testing will be inhibited.
Network Partner Check
This check looks for an active network device (i.e., PC/HUB). If an active device is
detected, the type of device is displayed along with its network capabilities indicated
with a tick as shown.
The capabilities ticked show the possible transmis-
sion rates possible for the device detected (IEEE802.3
standard). Below is a more detailed explanation of the
capabilities:
10 Base-T: This indicates that the device is capable of
transmitting data at a rate of 10 Mbps half duplex.
10 Base-T FD: This indicates that the device is
capable of transmitting data at a rate of 10 Mbps full
duplex.
100 Base-TX: This indicates that the device is capable
of transmitting data at a rate of 100 Mbps half duplex.
100 Base-TX FD: This indicates that the device is
capable of transmitting data at a rate of 100 Mbps full
duplex.
100 Base-T4: This indicates that the device is capable
of transmitting data at a rate of 100 Mbps using four
pairs.
10
PC detected with
capabilities indicated.
Hub/switch detected with
capabilities indicated.