Table of Contents
Advertisement
Configuration
Configuration
The track boundary is specified in the Data Area frame. See "Data Area" on page 314.
ID Radius
OD Radius
Max Track #
Track Pitch
Disk Size
In Spindle Frame, the speed and acceleration of the spindle rotation can be specified.
RPM
Acceleration
Figure 4-14
Spindle Acceleration
230
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specifies the radius from the center of the disk
to the innermost track.
Shows the radius from the center of the disk to
the outermost track. This is computed from the
parameters [ID Radius], [Max Track #] and
[Track Pitch]. OD Radius = ID Radius + (Max
Track # * Track Pitch).
Specifies the number of the innermost track.
The outermost track number starts at 0. The
number of tracks is equal to the number of
specified tracks plus 1.
Specifies the distance between the centers of
two adjacent tracks.
Shows the size of the disk. This parameter is
specified at the factory.
Specifies the speed of spindle rotation.
Specifies the acceleration of the spindle
rotation.
Acceleration
Slow Acceleration
Fast Acceleration
[rpm/sec]
2500
10000
Chapter 4
Advertisement
Table of Contents
