Setup Instructions - Greenlee Fairmont H4645 Operation, Service And Parts Manual

Setup Instructions

For ease of handling, the rail saw is shipped as two
component pieces. It is more convenient to move
the two as separate pieces between different locations
on the job site and for storage. The rail clamp/arm
assembly and the powerhead must be assembled
before cutting rail.
Attach Clamp and Arm Assembly to Rail
The clamp and arm assembly must be attached
to the rail before using the tool.
1. Place the clamp assembly on top of the rail.
The cleats inside of the clamp should rest snugly
under the rail head (see figure 3).
2. Tighten clamp screw until it grips the side of the
rail head.
WING
NUT
Greenlee Textron Inc. / Subsidiary of Textron Inc.
H4645 Rail Cut-Off Saw
CLAMP/ARM
ASSEMBLY
Connect Powerhead to Clamp and Arm Assembly
1. Remove wing nut from pivot bolt on powerhead.
2. Extend upper arm of clamp and arm assembly.
3. Slide pivot bolt through hole in upper arm.
4. Screw the wing nut onto pivot bolt (see Figure 4).
Figure 4
POWERHEAD
9 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Figure 3
CLAMP SCREW