Table of Contents
Advertisement
Setup Instructions (cont'd)
Do not place any part of the body over the rotating
cutting wheel.
Failure to observe this warning could result in
severe injury or death.
Mounting a new cutting wheel: (See Figure 6)
1. Remove shaft clamping nut and outer flange.
2. Remove old cutting wheel.
3. Discard old wheel and blotters.
4. Clean the clamping surfaces of inner and outer
flanges thoroughly.
Note: Blotters must always be used between flanges
and abrasive cutting wheel surfaces to ensure
uniform distribution of flange pressure.
5. Place new blotters, flanges and cutting wheel
together inside wheel guard.
6. Line up pin in outer flange with groove on the
inner flange.
7. Attach items to arbor with clamping nut.
8. Tighten nut so that cutting wheel is gripped firmly
between flanges. Tighten nut to 20 ft. lb. Torque.
9. Every time a new wheel is mounted, or a used wheel
is remounted, it should be run at operating speed
with safety guard attached at least one minute
before applying work.
New or remounted wheels should run at operating
speed for one full minute before use.
Failure to observe this warning could result in
severe injury or death.
Greenlee Textron Inc. / Subsidiary of Textron Inc.
H4645 Rail Cut-Off Saw
11
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Figure 6
NUT
OUTER
FLANGE
BLOTTER
CUTTING
WHEEL
Advertisement
Table of Contents
