Table of Contents
Advertisement
Hoses and Fittings
Hoses and fittings used with this tool must comply with SAE Standard J1273
(See Appendix A) recommended practice for selection, installation and
maintenance of hose and hose assemblies.
Failure to observe these warnings could result in over-pressurizing the
system causing severe injury to operator or bystanders.
Hose assemblies and quick connect couplers are available from Greenlee Fairmont as accessories.
SEE BULLETIN ON GREENLEE FAIRMONT NO-DRIP COUPLERS AND HOSES. CONTACT AUTHORIZED
GREENLEE FAIRMONT DISTRIBUTOR.
Tool/Hose Connections
Always stop power source before connecting or disconnecting tool.
Read and understand the procedures for connecting and disconnecting hoses.
Failure to observe these warnings could result in over-pressurizing the
system causing severe injury to operator or bystanders.
Connecting Hoses (See Figures 1 and 3)
Note: Return (tank) hose connection should always be
connected before supply (pressure) hose
connection to prevent pressure build-up inside
the tool.
1. Stop the power source.
2. Connect the return (tank) hose from the power
source (port T) to the tool (T port).
3. Connect the supply (pressure) hose from the power
source (port P) to the tool (P port).
Greenlee Textron Inc. / Subsidiary of Textron Inc.
H4645 Rail Cut-Off Saw
Disconnecting Hoses (See Figures 1 and 3)
Note: Supply (pressure) hose connection should always
be disconnected before return (tank) hose
connection to prevent pressure build-up inside
the tool.
1. Stop the power source.
2. Disconnect the supply (pressure) hose from the
power source (port P) to the tool (P port).
3. Disconnect the return (tank) hose from the power
source (port T) to the tool (T port).
4. To prevent contamination, always install dust caps
over the hydraulic ports of the tool when discon-
nected.
8
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Advertisement
Table of Contents
