Troubleshooting (cont'd)
PROBLEM
Tool operates slowly. (cont.)
Tool operates too fast.
Tool feels hot.
Greenlee Textron Inc. / Subsidiary of Textron Inc.
H4645 Rail Cut-Off Saw
PROBABLE CAUSE
Hydraulic fluid level low.
Hydraulic fluid viscosity too heavy.
Tool components loose.
Dirt, contaminants, etc., in components.
Tool components worn or damaged.
Power source speed excessive.
Power source components not adjusted
correctly.
Hydraulic fluid level low.
Hydraulic fluid viscosity too light.
Hydraulic fluid dirty.
Tool control valve stuck in partial
power-ON position.
Power source speed excessive.
Dirt, contaminants, etc., in components.
Worn or damaged O-rings or gaskets.
Tool components worn or damaged.
15
POSSIBLE REMEDY
Check fluid level. Fill to FULL mark.
Check system for leaks.
Use fluid viscosity recommended.
See Recommended Hydraulic Fluids.
Tighten component hardware.
Disassemble tool. Clean components.
Disassemble tool. Replace worn or
damaged components.
Refer to power source manual for
recommended power source speed.
Refer to power source operator's
manual for proper adjustment of
components.
Check fluid level. Fill to FULL mark.
check system for leaks.
Use fluid viscosity recommended.
See Recommended Hydraulic Fluids.
Drain reservoir, flush and fill with
clean fluid.
Free spool so it returns to neutral
position.
Refer to power source operator's
manual for proper adjustment of
components (flow).
Disassemble tool. Clean components.
Replace worn or damaged O-rings
or gaskets.
Disassemble tool. Replace worn or
damaged components.
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070