Greenlee CS-2072 Instruction Manual page 5

Identification
Receiver
1. Sensor
2. Circuit indicator LED (green)
3. Power indicator LED (red)
4. ON/OFF switch
5. Sounder
6. Belt clip
7. Orientation label (on back)
Transmitter
8. Plug (on back)
9. Power indicator LED (red)
10. Receiver clip
Symbols on the Unit
Warning—Read the instruction manual
Double insulation
Recycle product in accordance with
manufacturer's directions
Introduction
The Greenlee CS-2072 Circuit Breaker Finder consists of a transmitter and a
receiver. When plugged into an energized circuit, the transmitter will generate a
signal that can be detected by the receiver, which will give an audible and visual
indication at the correct breaker.
Opening and Closing the Unit
To separate the receiver from the transmitter, hold the
transmitter and pull upward on the receiver's handle.
8
9
10
To reassemble the receiver to the transmitter, place
the bottom center of the receiver over the transmitter's
receiver clip. Rotate the receiver wand into the
transmitter unit until it clicks in place. Use the belt clip
for easy transport.
CS-2072
1
2
3
4
ON
OFF
5
6
7
5