Vfp28In Log Placement - Empire Comfort Systems VFP20IN30L10-1 Installation Instructions And Owner's Manual

Unvented gas fireplace models

Hide thumbs

Table Of Contents

Table of Contents

Before you begin: Do not, handle these logs with your bare hands!

Always wear gloves to prevent skin irritation. After handling logs,

wash your hands gently with soap and water.

All Logs

The positioning of the logs is critical to the safe and clean operation

of this heater. Sooting and other problems may result if the logs are

not properly and firmly positioned in the appliance.

WARNING: Failure to position the parts in accordance with this

diagram or failure to use only parts specifically approved with

this appliance may result in property damage or personal injury.

PROPER INSTALLATION SEQUENCE:

(Figure 27)

1. Place rear log (#1) onto two (2) pins on rear log support.

2. Place left, front log (#2) onto two (2) left, front pins on burner

pan.

3. Place right, front log (#3) onto two (2) right, front pins on burner

pan.

4. Place Y Branch (#4) onto two (2) pins on rear log.

Compare the completed log installation with the photo on page

27. Review previous steps to make any necessary adjustments.

Log placement is completed.

7. Attach log placement plate to cable holding lighting instructions

for future reference.

Attention: Do not use Figure 27 to order replacement logs. Refer

to Page 46 Parts List and Parts View to order logs.

Rock wool can be added to burners for a glowing ember effect.

Apply loose material (glowing embers) only on locations shown on

Page 27. Replacement of loose material (glowing embers) must be

purchased from Empire Comfort Systems, Inc. Application of excess

loose material (glowing embers) may adversely affect performance

of the heater.

WARNING: All previously applied loose material must be

removed prior to reapplication.

8. Install front frame assembly.

Page 26