Vfp28In Log Placement - Empire Comfort Systems VFP20IN3 series Owner's Manual

Unvented
Hide thumbs Also See for VFP20IN3 series:
Table of Contents

Advertisement

Before you begin: Do not, handle these logs with your
bare hands! Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently with soap and
water.
All Logs
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may
result if the logs are not properly and firmly positioned in the
appliance.
Warning: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
PROPER INSTALLATION SEQUENCE:
(Figure 27)
1. Place rear log (#1) onto two (2) pins on rear log support.
2. Place left, front log (#2) onto two (2) left, front pins on
burner pan.
3. Place right, front log (#3) onto two (2) right, front pins on
burner pan.
4. Place Y Branch (#4) onto two (2) pins on rear log.
5. Compare the completed log installation with the photo on
page 27. Review previous steps to make any necessary
adjustments.
6. Log placement is completed.
7. Attach log placement plate to cable holding lighting
instructions for future reference.
Attention: Do not use Figure 27 to order replacement logs.
Refer to Page 46 Parts List and Parts View to order logs.
Rock wool can be added to burners for a glowing ember
effect. Apply loose material (glowing embers) only on
locations shown on Page 27. Replacement of loose material
(glowing embers) must be purchased from Empire Comfort
Systems, Inc. Application of excess loose material (glowing
embers) may adversely affect performance of the heater.
WARNING: All previously applied loose material must
be removed prior to reapplication.
8. Install front frame assembly.
Page 26

VFP28IN LOG PLACEMENT

Replacement Loose Material (glowing embers) Part
Number: 15999
Note: A single layer of embers is to be used when
applying Platinum Bright Embers (alone or in combination
with production embers) to the burner.
1
2
Log Placement
Figure 27
The following WARNING applies when log set is installed
onto an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or
propane) gas. Field conversion is not permitted.
4
3
29829-14-1114

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents