Lincoln Electric POWERTEC i320C STANDARD Operator's Manual page 20

Figure 25.

Create or choose a file in which will be saved copies
of the data.

The display shows the Save Data Menu on a USB
Memory Stick.
Figure 26.
 
Use the Set Control [11] to highlight the data icon
which will be saved in the file on a USB Memory
Stick. For example: Configuration Menu icon.
Figure 27.

Press the Right Knob [36] to confirm.
Figure 28.
English

To confirm and save the data on a USB Memory
Stick, highlight the Check Mark icon and then press
the Right Knob [36].


To exit the USB Menu – press the Left Button [37] or
disconnect the USB Memory Stick from the USB
receptacle.
Load – restore the data from the USB
Device to the machine memory.
To load the data from USB Memory:

Connect the USB to welding machine.

Add USB icon to the Welding parameters bar [44].

Use the Right Knob [36] to highlight the icon "USB".

Press the Right Knob [36] to confirm the selection – the
USB menu is shown on the display.

Use the Right Knob [36] to highlight the icon "Load".

Press the Right Knob [36] to get access of Load
option – the load menu is shown on the display.

Select the file name with the data to be loaded into
interface. Highlight the file icon – use the Right Knob
[36].
18
Figure 29.
Figure 30.
Figure 31.
English