Lincoln Electric POWERTEC i320C STANDARD Operator's Manual page 17

Table 9.
Symbol Description
t1
Preflow
Postflow
t2
Burnback Time
Spot Welding
Run-In WFS
Start Procedure
Crater Procedure
A/B
A/B Procedure
Load memory
Save memory
USB Memory
WARNING
To change the Parameters or Functions Value, theirs
icons had to be added to the Welding Parameters Bar
[44].
To add the Parameter or Function to the Welding
Parameters Bar [44]:

Access to the User Setup (see the Figure 13).

Use the Right Knob [36] to highlight the parameter or
function icon which will be added to the Welding
Parameters Bar [44], for example Run-in WFS.
Figure 14.

Press the Right Knob [36] to confirm the selection.
Run-in WFS icon will drop.
English
To remove the icon - press the Right Knob [36] once
again.
To exit the User Setup Menu – press the Left Button
[35].

The Selected parameters or function is added to the
Welding Parameters Bar [44].
To remove the selected parameter or function from the
Welding Parameters Bar [44]:

Access to the User Setup.

Use the Right Knob [36] to highlight the parameter or
function icon which is added to the Welding
Parameters Bar [44].

Press the Right Knob [36] – The selected icon will
disappear from the display bottom.
15
Figure 15.
WARNING
Figure 16.
Figure 17.
English