Monte Carlo Fan Company Prairie 14PRR52 D Series Owner's Manual And Installation Manual page 5

11
Partially loosen one and remove one
preassembled screw from mounting
bracket. Save screw.
14
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
© 2018 Monte Carlo Fan Company
12
Lift canopy up, aligning its keyhole slot
with the preassembled screw on
mounting bracket and twist
counterclockwise to lock in place.
Reinstall the screw removed in step 11
and tighten all screws securely.
Attach canopy bottom cap onto canopy
by aligning its notch with the screws on
mounting bracket and twist clockwise till
tight.
15
Plate on motor
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
5
13
Set screw
Washer
Blade
Blade bracket
Install blades, aligning the holes of blade
bracket and blade.
Install blade bracket with blade by blade
setscrews and washers provided. Tighten
screws securely. Repeat this process for
remaining blades.
16
Light pan
Place light pan over the light lead wires
and attach it onto the plate on motor,
aligning the keyhole slots on the light pan
with the preassembled screws on the
plate. Twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
05/2018