Monte Carlo Fan Company Prairie 14PRR52 D Series Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
4
Downrod
Remove preassembled keeper pin and
cross pin from downrod.
© 2018 Monte Carlo Fan Company
2
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
Downrod
Canopy
Keeper pin
Canopy bottom
cap
Cross pin Yoke cover
Place downrod over canopy, canopy
bottom cap and yoke cover
3
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member (a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting bracket with
the holes of the outlet box. Reinstall the 2
outlet box screws securely.
6
Screwdriver
Partially loosen downrod set screws from
yoke at top of motor assembly.
Thread lead wires and safety cable from
motor assembly through downrod.
Helpful hint:
cross pin on the next installation step.
After slip downrod into the motor yoke,
carefully insert a Phillips screwdriver through
the yoke and downrod ( don't damage the
lead wires ) as a guide and then push the
cross pin and pull the screwdriver in the
meantime as shown in the inset.
3
Mounting bracket
Lead wires
Safety
cable
Downrod
Canopy
Yoke
Canopy
cover
bottom cap
Yoke
Set screw
Cross
pin
For easy assembling of the
05/2018