Table of Contents
Advertisement
CLEANING YOUR LYNX GRILL (Including Required Maintenance)
TRIDENT ™ BURNER
It's easy to keep your Trident ™ burner operating at peak
performance. Just run it on "HI" with the hood open for 5
minutes after each use to burn away any food particles or
drippings.
Any ash accumulation on the burner screen can be
removed with a light brush or vacuum ... BUT WAIT UNTIL
THE BURNER IS COOL! Never use water or liquid to clean.
Every 3 to 6 months, remove the burner and inspect the
venturi (inlet) and orifice to ensure that they're free of
obstructions.
Food debris on the inside of the burner can be gently
shaken out. Do not touch the ceramic surface.
When re-installing the Trident ™ burner, be sure to correctly
position the burner.
WARNING: REQUIRED MAINTENANCE
1. Failure to perform required maintenance will void your warranty.
2. Clean out port holes on all ceramic burners if necessary with a plastic scouring pad.
3. Scrape the bottom of the firebox with a plastic putty knife or similar tool and discard the residue.
4. Clean out the burner orifices and ensure they are free of debris.
5. Clean the drip tray.
TROUBLESHOOTING YOUR LYNX GRILL
BEFORE YOU CALL FOR SERVICE
Please check a few things before calling for service:
• Is there fuel supplied to the grill?
• Is the main shut-off valve open?
• Are you using the correct type of fuel? (LP or Natural Gas)
(See INDEX: "Gas Requirements" for further details.)
Inside View, Orifice all
the way into venturi
• Is your propane cylinder empty? Have you recently
refilled the propane cylinder? If so, is the connection
tight?
• Have you opened the valve on the propane cylinder?
• Is the grill plugged in to a live electric circuit?
If you've checked the above items, review the
trouble-shooting list below before calling for Lynx for
service.
...continued
Heat Shield Removed,
Orifice/Venturi Position
CARE & USE/INSTALLATION
|
33
Hide quick links:
Advertisement
Table of Contents
