Operation And Care Of Your Appliance; Gas Controls/Control Compartment Access - Lennox Hearth Products MERIT Plus Series Care And Operation Instructions Manual

Mpd direct-vent gas fireplaces
Hide thumbs Also See for MERIT Plus Series:
Table of Contents

Advertisement

LENNOX HEARTH PRODUCTS • MERIT PLUS

OPERATION AND CARE OF YOUR APPLIANCE

Young children should be carefully supervised when they are in the
same room as the appliance. Toddlers, young children and others
may be susceptible to accidental contact burns. A physical barrier is
recommended if there are at risk individuals in the house. To restrict
access to a fireplace or stove, install an adjustable safety gate to keep
toddlers, young children and other at risk individuals out of the room
and away from hot surfaces.
Les jeunes enfants devraient être surveillés étroitement lorsqu'ils se trou-
vent dans la même pièce que l'appareil. Les tout petits, les jeunes enfants
ou les adultes peuvent subir des brûlures s'ils viennent en contact avec
la surface chaude. Il est recommandé d'installer une barrière physique
si des personnes à risques habitent la maison. Pour empêcher l'accès à
un foyer ou à un poêle, installez une barrière de sécurité; cette mesure
empêchera les tout petits, les jeunes enfants et toute autre personne à
risque d'avoir accès à la pièce et aux surfaces chaudes.
Main Gas
Shut-Off Valve
Main Gas
Shut-Off Valve
*CPI Switch - Switches from an
intermittent pilot mode to a stand-
*CPI Switch - Switches from an
ing pilot mode (a standing pilot
intermittent pilot mode to a stand-
stays lit when the fireplace is off).
ing pilot mode (a standing pilot
stays lit when the fireplace is off).
Main Gas
Shut-Off Valve
Main Gas
Shut-Off Valve
Figure 1: Control Compartment
8
DIRECT VENT GAS FIREPLACES (MPD33/35/40/45) • CARE AND OPERATION INSTRUCTIONS
®
WARNING
AVERTISSEMENT
Burner Assembly
Burner Assembly
DFC Board
Battery
Gas Valve
DFC Board
Holder
Battery
CPI Switch*
Gas Valve
Holder
*CPI Switch Positions
CPI Switch*
(o) = Intermittent Pilot Mode
*CPI Switch Positions
(-) = Standing Pilot Mode
(o) = Intermittent Pilot Mode
(-) = Standing Pilot Mode
Electronic Model
Pilot Assembly
Burner Assembly
Pilot Assembly
Burner Assembly
Gas Valve
Gas Valve
(Optional) Burner
ON/OFF Switch
(Optional) Burner
ON/OFF Switch
Millivolt Model
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Pilot Assembly
Pilot Assembly
Door Latch
Door Latch
Piezo
Door Latch
Piezo
Door Latch
Gas Controls/Control
Compartment Access
Operation of millivolt and electronic gas
control systems is different. Before lighting
and operating your appliance, determine
whether you have a millivolt or electronic
appliance.
The gas controls can be found behind the
lower access panel.
To open the panel, press the upper right
corner of the panel until the spring-loaded
magnetic catch is released. Then gently pull
the panel forward to release the left magnetic
catch and allow the panel to swing down
to open.
On millivolt systems, the piezo igniter, Hi/
Lo flame adjustment knob, pilot and main
gas ON/OFF control knob, and gas valve
(Figure 1) are located behind the lower
access panel.
On electronic systems, the hi/lo flame
adjustment knob and gas valve are located
behind the lower access panel.To remove the
lower access panel, slide the hinge pin on
the left side of the panel to the RIGHT until
it disengages from the left corner post hole.
Pull the panel diagonally to the LEFT, away
from the fireplace.
To ease panel replacement, press the spring-
loaded catches to temporarily lock them in
their retracted position, and then close the
panel.
Refer to Figure 1 for access to the gas
control valve. Millivolt appliances will be
fitted with the gas control valve shown in
Figure 2.
Appliances with electronic systems will be
fitted with the electronic valve shown in
Figure 3. Familiarize yourself with the gas
control valve that your appliance uses.

Advertisement

Table of Contents
loading

Table of Contents