Operation/Care Of Your Appliance; Gas Controls Access - Lennox Hearth Products ELDV-35NM Care And Operation Instructions Manual

OPERATION AND CARE OF YOUR APPLIANCE
Young children should be carefully supervised when they are in the
same room as the appliance. Toddlers, young children and others
may be susceptible to accidental contact burns. A physical barrier is
recommended if there are at risk individuals in the house. To restrict
access to a fireplace or stove, install an adjustable safety gate to keep
toddlers, young children and other at risk individuals out of the room
and away from hot surfaces.
Les jeunes enfants devraient être surveillés étroitement lorsqu'ils se trou-
vent dans la même pièce que l'appareil. Les tout petits, les jeunes enfants
ou les adultes peuvent subir des brûlures s'ils viennent en contact avec
la surface chaude. Il est recommandé d'installer une barrière physique
si des personnes à risques habitent la maison. Pour empêcher l'accès
à un foyer ou à un poêle, installez une barrière de sécurité; cette mesure
empêchera les tout petits, les jeunes enfants et toute autre personne à
risque d'avoir accès à la pièce et aux surfaces chaudes.
f i r e - p a r t s . c o m
Gas Line Access Plate Not Installed
At The Factory. It Is Included In
The Installation Instruction Bag.
Gas
Supply
Shut-Off Valve
Line
(Orientation
As Shown)
Figure 1
Gas Controls/Control Compartment Access
The gas controls can be found behind the control compartment access door.
Removing Control Compartment Door:
The control compartment door sits in place below the front glass enclosure panel. The door sits
on the lower cabinet frame and is located by tabs on either end of the engage slots on the fireplace
side rails. To remove the door, grasp it and pull it away from the fireplace.
8
WARNING
AVERTISSEMENT
ON
OFF
ON/OFF
Switch
Gas Valve
Piezo Ignitor
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Right Corner Post
Air Shutter
Adjustment Arm
To replace the door, engage the tabs with the
slots and push it into position.
On millivolt systems, the piezo igniter, HI/LO
flame adjustment knob, and pilot and main
gas OFF/ON control knob are located below
the glass panel enclosure. The gas valve for
electronic systems is also located below the
glass enclosure panel (see Figure 1).
The standard controls for appliance operation
are located behind the panel below the appliance
front glass enclosure panel (Figure 1). Optional
control switches are also available.
Operation of millivolt and electronic gas con-
trol systems are different. Before lighting and
operating your appliance determine if you have
a millivolt or electronic appliance. Familiarize
yourself with the gas control valve that your
appliance uses. Refer to Figure 1 for access to
the gas control valve.
Millivolt Appliances - Appliances with
Millivolt systems will be fitted with the gas
control valve shown in Figure 2.
Electronic Appliances - Appliances with
electronic systems will be fitted with the
electronic valve shown in Figure 3.
Millivolt Appliances - To light millivolt ap-
pliances refer to Figure 1. Detailed lighting
instructions are found on Pages 22 and 23.
Millivolt appliance lighting instructions may
also be found on the pull out lighting instruction
labels attached to the gas control valve.
Once the pilot is lit, the main burner may be
turned ON and OFF using wall switch, remote
control, optional on unit rocker switch (FRS),
or wall thermostat. To operate: Toggle the
switch between its ON and OFF positions.
If your millivolt appliance is equipped with an
optional remote switch kit (wall switch, remote
control, rocker switch, or wall thermostat) and
the pilot is lit, the appliance main burner may be
turned on and off using the optional switch.
Note: To prevent excessive resistance in burner
circuit (which can cause burner operation prob-
lems), only one burner control switch should
be wired to valve.