Installation; Environment Check - BenQ InstaShow WDC10TC User Manual

Installation

This section will guide you on how to prepare the unit before its initial use.

Environment check

Before installing your InstaShow™ kit, check the environmental conditions.
1. Do not install the device near heat sources like radiators or direct sunlight, or in a site with
excessive dust or humidity.
2. Ambient temperature conditions are listed as below. Maximum ambient temperature should be
+40°C or 104°F. Minimum ambient temperature should be +0°C or 32°F. Storage temperature
should be -10°C to +60°C (14°F to 140°F).
3. Humidity conditions are listed as below. For storage, the relative humidity should be 5% to 90%
(non-condensing). For operation, the relative humidity should be10% to 80% (non-condensing).
As your InstaShow™ works with different displays, the steps required to complete the installation
may vary according to the actual environment and your display specifications. Follow the procedures
below and refer to the specified sections for details.
1. Assemble the InstaShow Host with the antennas. See
for details.
2. Connect the InstaShow Host to the display and power properly. See
and power on page 16
• Attaching the InstaShow Host to the ceiling
• Attaching the InstaShow Host to a ceiling mount
• Placing the InstaShow Host on a table
• Installing the InstaShow Host on the wall or trolley
3. Connect the InstaShow Button to the desired devices and power properly. See
powering an InstaShow Button on page 19
4. Make sure that all the connected devices have been powered on. Press the source button of the
display and make sure that the HDMI source has been transmitted. See
Button and InstaShow Host on page 22
10 Installation
for details. Four installation methods are provided.
for details.
for details.
Assembling the InstaShow Host on page 11
Connecting the HDMI cable
Pairing a InstaShow
Setting up and