Changing The Flow Control - KitchenAid KEK1025 Owner's Manual

USING THE PRECISION KETTLE

CHANGING THE FLOW CONTROL

TIP: Prior to first use, fill the Precision Kettle with room temperature water and
pour at each flow control setting to become familiar with the different flow rates.
Your Precision Kettle has 3 flow
control settings. The flow control
1
lever inside the kettle is used to
change the settings.
NOTE: After heating water, be sure to empty the Precision Kettle and allow it to cool
completely before changing the flow rate settings.
TIP: The flow control lever is meant to come out for cleaning. If you pull up too far
while changing the flow rate settings and the lever comes out, it can easily slide back
into place.
FILLING THE PRECISION KETTLE WITH WATER
Remove the lid from the Precision
1
Kettle and fill with water.
NOTE: There must be a minimum of 1 cup (.25 L) of water for the Precision Kettle
to operate. Do not fill past the "Max" fill line of 1 quart (1 L).
Push the lever down for more
2
restricted flow; pull the lever up
for less restricted flow.
Replace the lid and put the Precision
2
Kettle back on the base.
USING THE PRECISION KETTLE | 7