Table of Contents
Advertisement
The image that was supposed to have uploaded to the WEB service is not there.
•
Upload may not complete when it is disconnected while transmitting the image.
•
It may take some time after uploading the image to be reflected in the WEB service depending
on the status of the server.
> Wait for a while and try again.
•
Transmission status can be checked in WEB destination settings by logging into the "LUMIX
CLUB".
I would like to return the image in the WEB service to the camera.
•
The images in the WEB Service cannot be saved (downloaded) to this unit. Do not delete the
uploaded images, and make a backup of them.
I cannot display or delete the images uploaded to the WEB service by this unit.
•
The images uploaded to the WEB service cannot be displayed or deleted by this unit.
> Perform the task using a smartphone or a PC.
Your "LUMIX CLUB" login ID and password were deleted after sending the
camera in to be repaired.
•
The settings stored in the camera may be deleted depending on the type of repair.
> Always make a copy of important settings.
There is an image that could not be transmitted.
•
Is the size of the image too large?
> Divide the motion picture using [Upload Size] (P133).
> Make the size of the still picture smaller using [Video Divide] (P104).
•
Capacity or number of images in the WEB service is full.
> Login to the "LUMIX CLUB", and check the status of the destination by WEB destination
settings.
I have forgotten the password for the Wi-Fi.
> Execute the [Reset Wi-Fi Settings] in the [Setup] menu.
> However, all the information set with the [Wi-Fi Setup] menu, such as the wireless access
point (broadband router), login setting of the "LUMIX CLUB", etc., will also be reset.
Transmission of the image fails midway.
•
Is the size of the image too large?
> Transmit after making the image the size of the still picture smaller with [Upload Size]
(P133).
> Transmit after dividing the motion picture with [Video Divide] (P104).
> Image cannot be transmitted when the battery indicator is flashing red.
Motion picture cannot be transmitted.
•
Only the motion pictures recorded in [MP4] can be transmitted.
•
Is the size of the image too large?
> Transmit after dividing the motion picture with [Video Divide] (P104).
Others
(P45)
- 180 -
Advertisement
Table of Contents
