Table of Contents
Advertisement
Using an AC adaptor (optional) and a DC coupler (For shop display purpose
only) instead of the battery
The AC Adaptor (optional) can only be used with
the designated Panasonic DC coupler (For shop
display purpose only). The AC adaptor (optional)
cannot be used by itself.
1 Open the card/battery door.
2 Insert the DC coupler, being careful of the
direction.
3 Open the DC coupler cover A.
•
Push open the coupler cover from the interior.
4 Close the card/battery door.
•
Ensure that the card/battery door is closed.
5 Plug the AC adaptor into an electrical outlet.
6 Connect the AC adaptor B to the [DC IN] socket
C of the DC coupler.
D Align the marks and insert.
•
Ensure that only the AC adaptor and DC coupler for
this camera are used. Using any other equipment may
cause damage.
Note
•
Always use a genuine Panasonic AC adaptor (optional).
•
When using an AC adaptor, use the AC cable supplied with the AC adaptor.
•
Some tripods cannot be attached when the DC coupler is connected.
•
Make sure to unplug the AC adaptor when you open the card/battery door.
•
If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
•
Also read the operating instructions for the AC adaptor and DC coupler.
Preparation
- 13 -
Advertisement
Table of Contents
