Table of Contents
Advertisement
NOTE
Your dishwasher uses a DishSense
adjusts the cycle accordingly.
Recommended Cycle for typical
use:
The Normal cycle with its factory default options
of normal temperature and heated dry together
provide the best all around performance. This
cycle selection is recommended for everyday use
and is suitable for a large range of both dish load
sizes and food quantities remaining on those
dishes.
Option Selections
Wash Pressure
The programmed cycles default to the "surge"
pressure option which varies the pressure
optimally for the cycle's intended normal use.
If, for some special circumstance, either a very
low "spray" or very high "scour" pressure is
desired that may be selected. Due to wash cycle
optimization, some pressure options are not
selectable in all wash cycle.
Wash Temp
The programmed cycles default to the "normal"
temperature option, to choose HI-TEMP or
SANITIZE press WASH TEMP pad.
Hi-Temp Wash Option
HI-TEMP WASH option is selected, by pressing
the WASH TEMP pad, the dishwasher heats water
in the main wash to approximately 140
This increase in water temperature helps
dishwasher detergent remove food grease and
soil from dishes more effectively and aids in
drying.
OPERATING INSTRUCTIONS
TM
Technology to understand how much food is on the dishes and then
Sanitize Option
To sanitize your dishes and glassware, select
SANITIZE option, by pressing WASH TEMP pad.
When selected, the light will come on and remain
on until end of cycle. The water temperature in
the fi nal rinse will be raised to 155
will maintain that temperature for 9 minutes. This
option is available in Heavy Wash/Power Plus and
Normal Wash Cycles. Only these sanitization cycles
have been designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120
The sanitize criteria may not be satisfi ed if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120
To turn off the SANITIZE option, press the Wash
Temp pad. The SANITIZE light will turn off.
Heat Dry
The HEATED DRY option in combination with rinse
aid will enhance drying performance. HEATED DRY
option is available on all cycles.
Air Dry
The AIR DRY option will reduce temperature in the
hot rinse of the selected wash cycle. This option
will slightly decrease energy usage but will increase
the likelihood that dishware will not be dry.
o
F (60
o
C).
o
o
F (49
C).
o
o
F (68
C) and
o
F (49
o
C).
5
Advertisement
Table of Contents
