Maintenance & Fault Finding - Raymarine T70152 Installation Instructions Manual

Maintenance & Fault Finding
Fault finding
SYMPTOM
The control unit display is blank
The displayed compass heading does
not agree with the boat's compass
Boat turns slowly and takes a long
time to come onto course
Boat overshoots when turning onto a
new course
The autopilot appears to be unstable in
Track mode, or track-holding is slow
The autopilot appears to be unstable
on Northerly headings in the Northern
hemisphere and Southerly headings in
the Southern hemisphere
Display shows CAL LOCK when entering
calibration
This chapter provides information about identifying common
problems, maintaining your autopilot system and obtaining product
support:
All Raymarine products are designed to provide many years of
trouble-free operation. We also put them through comprehensive
testing and quality assurance procedures before shipping.
In the unlikely event that a fault does occur with your autopilot, use
the following table to help identify the problem and provide a
solution.
SOLUTION
No power – check the fuse/circuit breaker.
You have not corrected the compass for
deviation – carry out the deviation and
alignment procedures
Rudder gain too low
Rudder gain too high
If tide speed exceeds 35% of boat speed, and
boat speed is not available via SeaTalk, change
the Cruise Speed setting in Dealer Setup to the
boat's cruising speed
Northerly/Southerly heading correction
(AutoAdapt) is not set up
Calibration lock is on – turn off the calibration
protection feature is in Dealer setup
29