Panasonic KX-NCP0158 Quick Installation Manual page 39

IP-CS is connected to must be set to "Trunk" port, to allow VLAN tagging. Consult your network
administrator for details.
•
It is possible to connect the IP-CS to the LAN while registering the IP-CS to the PBX. For details, refer
to "8 Registering IP Cell Stations".
1.
Connect the cable to the IP-CS.
2.
Pass the cable through the groove of the IP-CS in one of the following three ways.
1 1
To a Switching Hub
3.
Connect the other end of the cable to the switching hub.
Connecting an AC Adaptor to an IP-CS
IP-CSs comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your network,
these IP-CSs can receive the necessary power supply from the network through the network cable. In this
case, no AC adaptor is needed for the IP-CSs.
However, if PoE is not available, you will need to connect an AC adaptor to the IP-CS.
Document Version 2009-06
Ethernet Straight Cable
2
To a
Switching
Hub
7 Connecting IP Cell Stations
3
To a Switching Hub
Quick Installation Guide 39