Panasonic KX-NCP0158 Quick Installation Manual page 32

5 Site Survey Using the KX-TD7685/KX-TD7695/KX-TD7696
c.
Move away from the CS and identify the CS coverage area within which the radio signal strength level
is greater than "3". Draw the area on the map.
Radio Signal Strength Levels
For Establishing Conversation Using PSs
Level: 11 to 12
Level: 08 to 10
Level: 03 to 07
Level: 01 to 02
Level: 00
For Air Synchronization between CSs
Level: 12 or higher
Level: 05 to 11
Level: 03 to 04
Level: 00 to 02
3.
Repeat steps 1 and 2 for other CSs, and relocate the CSs when necessary.
a.
Plan the location of the CS so that its clock signal source is within range of the CS where the radio
signal strength level is "5".
Example
: Master CS1
: Master CS2
: Slave CSs (Primary CS: Master CS1, Secondary CS: Master CS2)
•
When planning the location of CS
area where the radio signal strength level of CS
32 Quick Installation Guide
Better
Good
May receive noise
Receives noise easily or disconnects
Out of range
May be reset due to synchronization failure of CSs
Good
Air synchronization is established. However, it is necessary to monitor
the status of synchronization using the Maintenance Console.
This is necessary because IP-CSs may be reset due to synchronization
failure if the radio signal strength fluctuates depending on changes in
the installation environment such as opening/closing doors.
May be reset due to synchronization failure of CSs
, make sure that CS
CH0
L:12
CH0
L:05
(clock signal source) is within the
is "5".
Document Version 2009-06
CH0
L:03