Interruption Of The Descaling Cycle - Gaggia Milano VELASCA RI8260 User Manual

English
14
CALC
CLEAN

Interruption of the descaling cycle

4219_460_3728_1_booklet_A5_v2.indd 14
9 Press the OK button to start the descaling cycle.
- The machine dispenses the entire descaling solution at regular
intervals through the steam wand and dispensing spout (this
takes approximately 25 minutes).
10 Wait until all of the descaling solution has been dispensed.
Remove and empty the container.
11 Remove and empty the drip tray. Slide the drip tray back into
the machine.
12 Rinse the water tank and fill it with fresh water up to the CALC
CLEAN indication. Slide the water tank back into the machine.
13 Place the container back under the steam wand and dispensing
spout.
14 Press the OK button to start the rinsing cycle (this takes
approximately 4 minutes).
- The display shows the following icon to indicate that the rinsing
cycle is finished.
15 The display shows a tick icon.
16 Rinse the water tank and fill it with fresh water up to the MAX
level. Place the water tank back into the machine.
17 Press the OK button to return to the main menu.
18 The display shows the following icon to indicate that the
machine is heating up.
- The machine performs an automatic rinsing cycle.
19 Remove the container. Remove and empty the drip tray. SLide
the drip tray back into the machine.
20 Place the water filter back in the water tank. Reinsert the classic
milk frother.
21 Remove and rinse the brew group see chapter 'Cleaning and
maintenance', section 'Clean the brew group'.
The machine is now ready for use.
Once the descaling cycle has started, you must complete it till
the very end without turning off the machine. In case you get
stuck during the cycle or in case of power failure or accidental
disconnection of the power cord, you can exit by pressing the
standby button. If this occurs, empty and rinse carefully the water
tank, then fill it up to the CALC CLEAN level. Follow the instructions
in chapter 'First installation', section 'Manual rinsing cycle' before
brewing any beverage. If the cycle was not completed, the machine
will require another descaling cycle to be performed at your earliest
convenience.
14/02/17 08:49