Installation; Unpacking The Beverage Refrigerator; Types Of Installation - EdgeStar BWC121SSLT Owner's Manual

Installation

The beverage refrigerator should be installed in accordance with local electrical code requirements.
The beverage refrigerator should also be placed in a location that is strong enough to support its total
weight, keeping in mind that it will weigh substantially more when fully loaded than when empty. Before
you plug the beverage refrigerator into a power supply, be sure to let it stand upright for at least
24 hours to allow the compressor's oils to settle.

Unpacking the Beverage Refrigerator

Warning: Use two or more people to move and install the beverage refrigerator. Failure to
do so can result in back or other injury. Carefully remove the packaging materials. Remove
any shipping tape and glue from your beverage refrigerator before use. Do not use sharp
!
instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your beverage refrigerator.
Warning: Do not remove any safety, warning, or product information labels from your
!
beverage refrigerator.

Types of Installation

This beverage refrigerator has been designed for freestanding or built-in installation. In each case,
there must be adequate ventilation and access for service.
Freestanding Installation:
A freestanding installation will allow you to install the beverage refrigerator in almost any place you
desire. You must follow the stated instructions for electrical requirements and leveling the beverage
refrigerator.
Warning: DO NOT install the beverage refrigerator behind a closed cabinet door.
!
Note: The beverage refrigerator should be installed on a firm and level surface that will
be able to support the entire weight of a fully loaded unit. It is important for the beverage
!
refrigerator to be level in order to work properly. If needed, you can adjust the height of
the beverage refrigerator by rotating the feet. See the "Leveling the beverage refrigerator"
section.
Note: A standard electrical supply (115V AC only, 60 Hz), properly grounded in accordance
!
with National Electrical Code and local codes and ordinances, is required.
7