To Open The Switch Box Cover Of The Indoor Unit; To Lower The Switch Box On The Indoor Unit - Daikin Altherma EAVX-D9WG Installer's Reference Manual

7 Installation
3
3 If necessary, remove the front plate. This is, for example,
necessary in the following cases:
▪ "7.2.5 To lower the switch box on the indoor unit" on
page 28
▪ "7.4.4 To connect the drain hose to the drain" on page 30
▪ When you need access to the high voltage switch box
2×
T25
7.2.4 To open the switch box cover of the
indoor unit
4×
T25
Installer reference guide
28
4×
T25
7.2.5

To lower the switch box on the indoor unit

During the installation, you will need access to the inside of the
indoor unit. To have easier front access, put the switch box lower on
the unit as follows:
Prerequisite: The user interface panel and front panel have been
removed.
1 Remove the top panel that keeps the switch box into place at
the top of the unit.
2 Tilt the switch box to the front and lift it out of its hinges.
2×
T25
1
3 Place the switch box lower on the unit. Use the 2 hinges located
lower on the unit.
EPGA11~16DAV3 + EAVH/X16S18+23DA6V+9W
Daikin Altherma – Low temperature split
4P556070-1 – 2019.02