Samsung NX58H9950WS User Manual page 62

Problem
The burners do not burn
evenly.
Very large or yellow
surface burner flames.
Surface burners light
but oven burners do not
light.
Oven
Problem
The oven control beeps
and displays an error
code.
Very large or yellow oven
burner flames.
Oven temperature is too
hot or cold.
Manual User_NX58H9500WS_DG68-00566A-01_EN_NonPF.indd 62
Possible cause
Surface burner components and
caps are not assembled correctly
and level.
Surface burners are dirty.
Wrong orifice is assembled.
The oven door lock is turned on.
Gas Pressure Regulator shut off
switch is in the 'off position.
Possible cause
You have a function error code.
See the "Information codes" chart
on page 67.
The oven burner air adjustment
shutters need to be adjusted.
Gas supply is not properly
connected or turned on.
Oven thermostat needs
adjustment.
English - 62
Action
See page 55.
Clean surface burner
components. (See page 54.)
Check the burner orifice size and
contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press the START/SET button
for 3 seconds. The oven will beep
and the Lock icon will turn off.
Call a qualified service technician.
Action
Press the OFF/CLEAR button and
restart the oven. If the problem
persists, disconnect all power to
the range for at least 30 seconds
and then reconnect the power. If
this does not solve the problem,
call for service.
Call for a qualified service
technician.
See the Installation Instructions
that came with your range.
See page 45.
2014-07-30 1:02:17