SmartRG SR505N User Manual page 30

Appendix A – Troubleshooting
Enter the information in the section. Explanations of parameters are
described below. Click the Apply / Save button to add the entry in the
Active Outbound IP Filtering table.
IP Filtering – Incoming
This window allows you to create a filter rule of Incoming.
Click change default policy to change the mode of policy.
Now default policy is ACCEPT, it means all incoming IP traffic from WAN
is accepted, but some IP traffic can be blocked by setting up filters.
If you are setting up the incoming IP filtering, click the Add button.
Now default policy is BLOCK, it means all incoming IP traffic from WAN is
blocked, but some IP traffic can be accepted by setting up filters.
If you are setting up the incoming IP filtering, click the Add button.
V33 User Manual 30